Guide

How to Use a Bertello Pizza Oven

Updated on · By the Crispy Neurons team

To use a Bertello pizza oven, light its burner and preheat the stone until it reads about 750 to 900°F, then slide a stretched dough onto the stone with a peel. Turn the pizza every 20 to 30 seconds and pull it once the crust is spotted and the top is set.

On this page (8 sections)
  1. What do you need before lighting a Bertello pizza oven?
  2. How do you choose the fuel for a Bertello oven?
  3. How long should you preheat the stone?
  4. How do you stretch and launch the dough?
  5. How do you turn the pizza while it bakes?
  6. How do you control the heat between pizzas?
  7. How do you clean and store the oven after cooking?
  8. What mistakes should you avoid when using a Bertello?

To use a Bertello pizza oven, light its burner and preheat the stone to about 750 to 900°F, then slide a stretched dough onto the stone with a peel. Turn the pizza every 20 to 30 seconds and pull it when the crust is spotted and the top is set.

The rest is technique. Fuel choice, a proper preheat and a confident launch decide whether the base crisps or the toppings burn.

This guide walks through how to use a Bertello pizza oven from a cold oven to the last pie.

What do you need before lighting a Bertello pizza oven?

Set up the oven outdoors on a stable, heat-proof surface before you light anything. A Bertello runs on a live flame, so it gives off carbon monoxide and must never cook inside a house, garage or tent.

Clear at least a few feet around the oven. Keep it away from walls, fences, overhangs and anything that can melt or catch fire.

Wind can push flames toward the front, so pick a sheltered spot or turn the oven so the wind hits the side.

Have your tools within reach: a peel, a thermometer, a brush and scraper, oven mitts and a small bowl of flour. Stack a few balls of dough on a floured tray so you can work quickly once the stone is hot.

Check the burner and gas line are connected properly and the valve is closed before you open the fuel. If you're using wood or charcoal instead, have dry fuel ready.

Read the full heat range in our guide to how hot does a pizza oven get so you know what to expect.

How do you choose the fuel for a Bertello oven?

Pick the fuel that matches your setup and the flavor you want. The Bertello is built to run on more than one source, so the same oven can cook with gas for speed or with wood and charcoal for smoke.

Gas is the simplest option. A propane tank connects to the burner and you control the flame with a knob, which makes the preheat steady and the temperature easy to adjust mid-bake.

It's the right choice for a first cook or a quick weeknight pie.

Wood and charcoal give a smokier crust and a more traditional feel. You light the fuel in the tray and let it burn down to hot embers before the stone reaches temperature.

Expect more attention, since you manage the fire as well as the pizza.

Gas suits small patios and people who want repeatable results. Wood suits cooks who enjoy the fire and don't mind a longer setup.

Either way, the oven needs to sit outdoors and stay clear of anything flammable.

How long should you preheat the stone?

Preheat on high for about 15 to 20 minutes before the first pizza. The stone holds heat slowly, so its surface temperature keeps climbing after the flames look strong.

Don't trust the flame alone. A hot oven and a cold stone are the classic reason a base stays pale while the top burns.

Give the stone the full preheat and check it with a thermometer before launching.

An infrared thermometer reads the stone surface in under a second, so you can confirm the center is in range. Aim the laser at the middle of the stone and scan the whole surface; edges often run cooler than the center.

If the stone reads low, wait a few more minutes. If it's running hot, ease the flame down a notch and give it a minute to settle.

A stone in the 750 to 900°F range cooks a thin pizza in about 60 to 90 seconds.

How do you stretch and launch the dough?

Stretch the dough to 10 to 12 inches on a floured peel, add toppings light, then slide it onto the stone in one confident motion. A 12-inch pie is the comfortable size for the standard Bertello.

Start from a rested dough ball. Press the middle flat and work outward with your fingertips, leaving a slightly thicker rim.

Lift and rotate the dough as you go, and keep the center thin so the base sets fast.

Dust the peel with flour or semolina right before you launch. Too much flour leaves a bitter burn on the stone; too little and the dough sticks.

Shake the peel gently to confirm the pizza moves before you commit.

Add sauce and toppings sparingly. A wet, heavy pie releases moisture that steams the base and slows the bake.

Keep cheese and sauce away from the rim so it doesn't spill and char.

To launch, open the oven, line the peel up at the back edge of the stone and tilt it slightly. Slide the pizza forward with a short push and pull the peel back in one smooth move.

Don't hesitate halfway; a stalled launch usually means a folded or stuck dough.

How do you turn the pizza while it bakes?

Turn the pizza every 20 to 30 seconds so one side doesn't scorch. The back of a Bertello runs hotter than the front, so a pie left alone will burn at the rear before the rest is done.

Use the peel to lift and rotate the pizza about a quarter turn each time. Work quickly, keep the oven door or mouth open as little as possible, and watch the crust color as your guide.

A thin crust can go from pale to charred in seconds.

If the toppings are set but the base still looks pale, raise the pizza briefly toward the hotter zone. If the crust is browning fast but the center looks wet, lower the flame and give it a few more seconds.

Pull the pizza when the rim is spotted and the underside is crisp. Set it on a board or rack for a moment before slicing; the cheese is molten straight from the oven.

Repeat for each pie, and keep the stone hot between bakes.

How do you control the heat between pizzas?

Check the stone between pies and adjust the flame before the next launch. Back-to-back baking cools the stone and shifts the temperature, so a quick thermometer check keeps results consistent.

If the stone has dropped, let the burner bring it back up rather than launching into a cooler oven. A short pause costs less time than a pale, doughy base.

If the stone is running hot after several bakes, ease the flame down a notch.

Watch for flour and debris building up on the stone. A quick scrape after each bake stops old bits from burning and smoking under the next pizza.

Let the stone cool slightly before a deep clean so you don't crack it with a cold tool.

A smaller oven also means less room to work, which is why many buyers choose a small pizza oven with a peel that matches the stone size. If you're weighing price against fuel options, our pick of the best budget pizza ovens covers what to expect at each tier.

How do you clean and store the oven after cooking?

Let the oven cool completely, then brush the stone and wipe the outside before covering it. Never pour water on a hot stone; the sudden change can crack it.

Once cool, brush loose ash and burnt flour off the stone with a stiff brush. Use the scraper side on stubborn spots and avoid soap on the stone, since it soaks in.

Wipe the outside with a damp cloth and dry it fully.

Empty the fuel tray or disconnect the gas and close the valve. Store the oven under a cover, away from rain, and keep it level so the stone doesn't shift.

A dry oven lasts far longer than one left out in the weather.

If you're still comparing brands before you buy, the Big Horn pizza oven guide shows how a rival model handles setup and heat.

What mistakes should you avoid when using a Bertello?

The biggest mistake is launching into a stone that hasn't finished heating. Give it the full 15 to 20 minutes and confirm the surface with a thermometer.

Other common slips include overloading the dough with wet toppings, leaving the pizza in one spot so the back burns, and cleaning a hot stone with water. Each one is easy to fix once you know it's coming.

For anyone learning how to use a Bertello pizza oven, the routine is simple: outdoors only, full preheat, a floured peel, frequent turns and a cool-down before cleaning. Follow that order and the oven rewards you with a crisp base and a spotted crust every time.

Frequently asked questions

Can you use a Bertello pizza oven indoors?

No. A Bertello runs on a live flame and gives off carbon monoxide, so it belongs outdoors on a heat-proof surface.

Keep it away from walls, overhangs and anything that can catch fire, and never bring it into a garage or tent to cook.

How long does a Bertello pizza oven take to heat up?

Give it about 15 to 20 minutes on high before the first pizza. The stone holds heat slowly, so the surface temperature climbs well after the flames look strong; a quick read with an infrared thermometer tells you when it's ready.

What size pizza fits a Bertello oven?

A 12-inch pie is the comfortable size for the standard Bertello. Stretch dough to roughly 10 to 12 inches so there's room to turn it with a peel, and keep the rim thin so the base sets before the toppings scorch.

Do you need a pizza peel to use a Bertello oven?

You can launch by hand, but a peel makes it far safer and cleaner. A 12-inch metal peel lets you stretch, carry and turn the pie without burning your fingers or dropping flour onto the stone.

How do you stop pizza sticking to a Bertello stone?

Dust the peel generously with flour or semolina before each launch, and keep the dough moving so it doesn't sit and absorb moisture. A hot stone plus a floured peel is what makes the slide work.